David and I finished the Faring the bottom and sides. The
transition looks very smooth
We also prepped the entire outside of the boat for finishing and
painting. It looks good, you will be surprised. There are no more troublesome
protruding screws
The only big fill areas will be the side spots in the middle of
the boat where we did not know to cut the curve and the transom
The transom will need some crafty fill work but will look good
if we take our time and do it right
The only area we did not prep is at the bow, we were thinking
that we still may wrap the front with metal
Next step is mix the epoxy and do a “test fill” to see how it
looks. If we like how it goes we can finish the entire outside of the boat
We should be able to flip the boat soon. I am going to start
working a design on the ribs. Based on the picture
Our options are to glue some scrap Marine plywood together
(about 3 layers) or we could get fancy and use some pretty lumber. We will need
to discuss next time
No comments:
Post a Comment